Whichever size you choose, try to be consistent. If you pick a pull that’s too short, it’ll look inappropriate on your wide drawer: it’s also more physically challenging to open a wider drawer with a short pull than with a long pull.īedroom furniture drawer pulls that are 5” long are easy to grip, yet they’re not too long that they look out of place on a smaller drawer or cabinet. If you’re looking for a pull for a wide drawer, you should get one that’s just over ⅓ of the length of the drawer. ![]() Standard dresser drawers range between 14-30”, while drawers used kitchen cabinets have a wider range from 9-48”. I had no problems and was thrilled at how easy it was to use once I understood the need to mix it well.Drawer pulls come in a wide variety of shapes, styles, and sizes, and the length of pull you choose should depend upon the width of the cabinet or cabinet. It is not hard to use – READ and familiarize yourself with the process before jumping right in to ensure you have success. It states in the directions that the resin should cure for a few days before using.įollow the EnviroTex directions to the letter. In the morning the resin was hard and shiny. Place them in a quiet room and cover them with a big box to protect them while they dry. Once I had all the pulls covered I let them dry overnight. I made small amounts and then mixed more as I needed it. If bubbles arise – gently exhale on them and they go away – like magic. ![]() It is amazing to watch the resin self level. I started in the center of a pull and worked out to each side. Then you pour it over the surface of the drawer pull. Basically you mix equal parts of the resin and hardener and mix it well – like you would cake batter –scraping the sides of the mixing container as you mix for 2 minutes. ![]() Since you have to work quickly with EnviroTex Lite, I don’t have any photos of the process. To keep the pull functioning –apply the resin thicker in the middle of the pull as it is self leveling and just make sure the area around the joint gets just a little bit to look shiny. I made this mistake on the first few I did. Important Note: When applying the EnviroTex Lite around the two ball joints that hold the handle – do it sparingly! Just add a thin layer so the area will look shiny– do not make it thick or it will go into the handle attachment and keep the handle from moving when it dries as well as fill in the screw hole on the back. Make sure the toothpicks are angled up and not touching the sides of the pulls. Place a toothpick into one or both of the ball joints so the handle will stay up. ( Lyn – a reader left a comment saying that sugar cubes make perfect blocks to place the handles on – Thanks Lyn for that great tip) Use little blocks of wood or wax/plastic wrap covered foam blocks so the pulls can easily be removed from the blocks when they are dry. ![]() It was not hard to remove, but one extra step. I used foam, but some of it stuck to the back when the resin was dry and I needed sand paper to remove it. Each pull needs to be placed on a block so the EnviroTex Lite can run off it. The Best DIY Chalk Paint Recipe For Painting Furniture.Chalk Paint Furniture Before & After Makeovers.Tips That Will Make Paint Clean Up… Easy!.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |